2007 Toyota Tundra Dash Removal

Remove the three screws that secure the blend door actuator to the passenger side of the HVAC air distribution housing.

2007 toyota tundra dash removal. Remove the blend door actuator from the vehicle. Figure E Continue to kit assembly Figure D Figure E Toyota Tundra console shift 2007-up Toyota Sequoia 2008-up. Remove storage tray from lower dash panel.

Using the Five provided screws insert them into the dash mount holes and rest the mount on the dash making sure none of the hardware for the ball mounts interfere with the dashboard. Removing the dash speakers. Do not let the lower dash panel fall because the hood release lever and obd scanner plug are attached to it.

Bolts behind ash tray. Remove the three bolts nut and number one brace. Using trim tools remove the center dashboard speaker cover.

At this point Install your mounts ie. Unclip the right side of the instrument panel trim and pull back the trimthen unclipunplug and remove radio. Figure A 2 Unclip unplug and remove the cli-mate control assembly.

Remove the three or four bolts holding the heater case to the dash. In the case of the regular system the factory setup includes 2 tweeters at each corner of the dash just below the windshield. My 2007 Toyota Tundra 47l shows VSC OFF lights.

Because the inlet tubes project through the firewall the unit will not fall straight down. Maybe need to replace spark plugs try to reset the ecu for a momentany malfunction remove the negative battery terminal few minutes and reconnectstart engine and drive check if lights goes off please write me. TOYOTA TUNDRA 2007 - TVIP V5 Procedure RS3200 PLUS Issue B.