2000 Toyota Tundra Rear Axle Removal

My problem was the axle seal kept failing and leaking oil which made the bearings fail because lack of lubrication.

2000 toyota tundra rear axle removal. Im installing a rear axle bearing oil seals on my 1985 Toyota Pickup 4x4 without using a press. They are located behind the rear brake drums. Toyota Tundra Forum.

Remove the 10mm bolt holding the parking brake cable to the rear of the hub assembly and pull the cable assembly out the back. On AmazonREAR WHEEL BEARING KIT. Hello everyone Im the proud owner of an 03 Tacoma 4x4.

Genuine Toyota Parts the Right Choice. Remove e-brake cable from rear drum and take off brake linecarefully. This will expose the parking brake cable end shown below.

Unfortunately for the truck I live in New England. I have been told that timkin bearings are not as good as they used to be years ago. 10 mm wrench Third remove the drain and fill plugs from the axle and let the fluid drain out into a container for proper disposal.

Parts like Rear Axle Housing Differential are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty. Next remove the 4 17mm nuts that hold the axle and bearing assembly to the axle tube. Fits 4Runner T100 Tacoma Truck TundraAxle Shaft Bearing - Repair or ReplaceAn Axle Shaft bearing can fail and result in a squeak or chirp noise or possibly as a whine or groan that can be mistaken for a wheel bearing noise.

You will loosen the lug bolts raise and support the truck remove the wheel then remove the brake drum then remove the 4 bolts that hold the backing plate onto the rear axle tube remove the brake line from the wheel cylinder disconnect the e-brake cable and then pull the axle out. They had rigged something to the hydraulic press and put some unbelievable. 14mm wrench Second remove the 2 brake lines from the drums.