2000 Toyota Tundra Ignition Switch Problems

First thing Id do though is remove the covers to all your fuserelay boxes.

2000 toyota tundra ignition switch problems. In the ACC position the radio or fan may be energized. And it can keep your Tacoma from starting in a couple of different ways. Start the car and get it to where it wont shut off like you describe then take a screwdriver and lightly smack each relay a few times with the handle see if anything happens.

You must remove the intake plenum to get to starter to fix or replace starterIf you are going to replace starter make sure the battery terminals on starter are in the correct placement for cables. Clean the connections and see if that elininates the trouble. The most recently reported issues are listed below.

2001 Toyota Tundra problems. And finally in the START position the starter relay is engaged. Much better than WD-40 because it wont attract dust.

The battery went dead on my 2000 tundra. Insert the vehicle key in the ignition. 2000 Toyota Tundra problems.

While there are a variety of reasons your Toyota Tundra key wont turn the most common 3 are a binding steering columnlock an ignition switch issue or a problem with the ignition key. The engine will just turn over with no spark. Generally speaking in the OFF position the ignition switch doesnt connect anything.

While it would seem like the most likely cause for a key to get stuck in the ignition at first compared to it being a bad key this is not nearly as likely. 2002 Toyota Tundra problems. Draw in RED the B current path from the STOP LIGHT SWITCH.