2000 Toyota Tundra Change Ignition Switch

Secure the switch with its screws.

2000 toyota tundra change ignition switch. To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. This part is also sometimes called Toyota Tundra Electronic Ignition Switch. Detach the illumination ring by pulling out the plastic pin on the side.

How to remove the ignition lock cylinder on a 2000 Tundra - Answered by a verified Toyota Mechanic We use cookies to give you the best possible experience on our website. Press the release bottom with this screwdriver as you pull the lock cylinder straight out. Note that the starter is UNDER the intake manifold.

It doesnt idle anymore. Turn the lock cylinder into the Accessory position with the key and insert a small screwdriver into the hole at the bottom of the ignition switch casting. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.

Secure the switch with its screws. Problems in getting anyone of my keys to turn the ignition. Remove the lower steering column cover.

This is a VERY difficult job and is not recommended to those who do not have sufficient automotive experience. Make sure both the lock cylinder and column lock are in the ACC position. Switch out of the lock position into starting my truck.

Designed to provide long-lasting service life Made utilizing state-of-the-art equipment 1958 - 2239. Make sure both the lock cylinder and column lock are in the ACC position. You can switch ignition coil to the other cylinder to check if the misfire follows that pack.