2000 Toyota Tundra Brake Light Reset

The contact stated while braking to a complete stop there was an abnormal bang from the rear of the vehicle.

2000 toyota tundra brake light reset. Another possibility is a brake fluid leak. Just tap the brakes rapidly 8 or more times about two taps per second. Now you need to open the hood again and disconnect the battery negative cable for a few seconds approximately 20 seconds use the right sized socket.

Thereafter if the system malfunctions the light comes on again. The dealer advised the rear axle was fractured and the axle was replaced. Depress the brake pedal 8 or more times within 5 secs.

Its the same one that comes on when you apply the e-brake. The parking brake and the low brake fluid use the same light. 6 Nov 17 2009.

Just have it towed to a mechanic. Connect terminals Tc and E1 of Check Connector in engine bay and remove the short pin normally inserted in bottom right corner. It would go off for a little while and then come back on.

If your Tundra is having trouble stopping or noticeably leaking fluid dont drive it. This is best done after any repair work to ensure the codes stay gone as. Even if your fluid level appears to be fine double check it.

You dont have to jam on the brakes just tap them enough to blink the brake lights. If you like to reset any maintenance oil light after an oil change. Make sure that it is filled to just below the max line.