200 Toyota Tundra Rear Axle Bearing Removal

If all you needed to replace was the oil seal you can now reassemble everything see below bleed the brakes and you are finished.

200 toyota tundra rear axle bearing removal. I used snap ring pliers and a screwdriver. Get it as soon as Thu Sep 23. There is a TSB on it as well T-SB-0297-10.

Remove the rear axle bearing. Luckily an 1-12 schedule 40 steel pipe fit perfectly over the axle. Our Toyota technicians have Access to all the OEM parts and follow factory.

To get started after pulling the axle I removed the retainer clip on the axle. I built a bearing puller adapter out of a 29 piece 3 schd 40 pipe with 12 plate on both ends total length 30. After the axle is removed disconnect the service tool.

For additional information refer to Axle Shaft in this section. Also it will fit any symmetrical 4-bolt. Its located just above the spacer that oil seal rides on.

Genuine Toyota Parts the Right Choice. I greased up the bearing axle and seal surfaces placed the axle on the cement floor slid the backing plate over the axle then slipped that old bearing retainer onto the axle to protect the bearing inner race from the beating I was going to give the pipe. I had a rear axle seal go out and when the tech took it out to install the new seal 200 miles from my tools he found the bearing had to be replaced so Im looking for tips on this.

Grasping the edges with vice grips and turning the center piece with need lose pliers works well. Remove the outer oil seal. Rear Wheel Bearing and Axle Shaft Oil Seal Removal.